[OP1]vlan 1 to 30
Please wait... Done.
[OP1]stp region-configuration
[OP1-mst-region]instance 1 vlan 1 to 30
[OP1-mst-region]active region-configuration
[OP1-mst-region]quit
[OP1]interface GigabitEthernet1/0/7
[OP1-GigabitEthernet1/0/7]undo link-delay
[OP1-GigabitEthernet1/0/7]undo stp enable
[OP1-GigabitEthernet1/0/7]qos trust dot1p
[OP1-GigabitEthernet1/0/7]port link-type trunk
Warning:This port is a member of the link aggregation group. If configuration of the whole group is required to be modified, please configure it under the aggregation interface view. Otherwise, this operation may interrupt network traffic.Continue?[Y/N]: n
[OP1-GigabitEthernet1/0/7]quit
[OP1]interface GigabitEthernet1/0/8
[OP1-GigabitEthernet1/0/8]undo link-delay
[OP1-GigabitEthernet1/0/8]undo stp enable
[OP1-GigabitEthernet1/0/8]qos trust dot1p
[OP1-GigabitEthernet1/0/8]port link-type trunk
Warning:This port is a member of the link aggregation group. If configuration of the whole group is required to be modified, please configure it under the aggregation interface view. Otherwise, this operation may interrupt network traffic.Continue?[Y/N]: n
[OP1-GigabitEthernet1/0/8]quit
[OP1]rrpp domain 1
[OP1-rrpp-domain1]control-vlan 4092
[OP1-rrpp-domain1]protected-vlan reference-instance 1
[OP1-rrpp-domain1]ring 1 node-mode transit primary-port GigabitEthernet1/0/7 secondary-port GigabitEthernet1/0/8 level 0
Error: An interface in an aggregation group cannot be configured with RRPP!
[OP1-rrpp-domain1]ring 1 enable
Info: This ring does not exist.
[OP1-rrpp-domain1]quit
[OP1]rrpp enable
[OP1]save
The current configuration will be written to the device. Are you sure? [Y/N]:n
[OP1]
请问这是什么情况？其他交换机没出现这个问题啊