mycloud （已经分不清GEN1 or GEN2，系统进不去了） 彻底红灯，原硬盘已经格式化了，未做镜像备份（手贱），现在找了一个新硬盘想重新用这个mycloud，翻阅一些资料发现需要原硬盘镜像来恢复，发现网页上的网盘镜像已经无法下载，求助各位吧友，不知道谁有，不胜感激。

###################################
#
# One of success-story with this howto:
# https://community.wd.com/t/my-cloud-gen2-using-an-8tb-hdd-and-formatting-failure-error-code-600/221499/1
#
###################################
0. Download these files:
http://support.wdc.com/downloads.aspx?g=904 (Original firmware)
https://ftp.anionix.ru/WDMyCloud/WDMyCloud-Gen2/usbrecovery.tar.gz (WD Recovery + My miniOS)
1. Use any USB Flash drive, format it to FAT32 (Important!)
2. Unpack usbrecovery.tar.gz to this drive (You will get "boot" folder and 4 files inside)
3. Plug this USB drive to WD MyCloud, turn on power. Wait yellow-red (blinking) light.
4. Connect via Telnet (Search IP in your router, unde DHCP section.)
5. Format HDD if need:
parted /dev/sda
mklabel gpt
mkpart primary 1049kB 2149MB
mkpart primary 8591MB -1MB
mkpart primary 7517MB 8591MB
mkpart primary 2149MB 3222MB
mkpart primary 3222MB 4296MB
mkpart primary 4296MB 6443MB
mkpart primary 6443MB 7517MB
q
mkswap /dev/sda1
mkfs.ext4 /dev/sda3
6. Install original WD recovery and reboot:
mkdir -p /mnt/usb /mnt/root
mount /dev/sda3 /mnt/root
mount /dev/sdb1 /mnt/usb
cp -r /mnt/usb/boot /mnt/root/
cd /mnt/root/boot
rm uImage uRamdisk
mv uImage-wdrecovery uImage
mv uRamdisk-wdrecovery uRamdisk
cd /
umount /mnt/root /mnt/usb
sync
reboot -f
7. After reboot device get old IP address and accessable via Web-GUI (Recovery mode). Use original firmware (.bin file) here.
Done!
=====================================
# Alternative way:
# Use Debian/ubuntu or any other linux distro (USB/CD Live image)
# All "/dev/sda" change to your disk! (List disks in system: "parted -l")
# If this is new disk or damaged (formatted) old, recreate partitions first:
parted /dev/sda
mklabel gpt
mkpart primary 1049kB 2149MB
mkpart primary 8591MB -1MB
mkpart primary 7517MB 8591MB
mkpart primary 2149MB 3222MB
mkpart primary 3222MB 4296MB
mkpart primary 4296MB 6443MB
mkpart primary 6443MB 7517MB
q
mkswap /dev/sda1
mkfs.ext4 /dev/sda3
# Download and unpack files from WDMyCloud/WDMyCloud-Gen2/Developing: uImage-wdrecovery and uRamdisk-wdrecovery
# Write it disk:
mkdir /mnt/boot
mount /dev/sda3 /mnt/boot
mkdir /mnt/boot/boot
cp uImage-wdrecovery /mnt/boot/boot/uImage
cp uRamdisk-wdrecovery /mnt/boot/boot/uRamdisk
# Done. Connect disk back to WDMC and turn on.
# After few minutes WDMC boots to "WD Recovery". Go to webgui and upload official firmware.
# Done!

50远程帮你刷系统，100包邮收主板盒子

链接：[无效] https://pan.baidu.com/s/1NzAWaBf2qO4ZsFCVMxxEPQ
提取码：qybx

哪位大佬分享下gen1镜像？感谢！