搬运个图纸，看起来很有意思的样子
... the windbow was designed by Etienne Veyres and Alain Chevalier of France... The Windbow is my [George Peters] version arch ribbon with a few added aerodynamic details to create a super wind toy. The open pocket detail on the battens allows for a slight bubble effect along the leading edge of the arch, increasing airfoil lift. It will fly at times directly overhead. The longer curve on the trailing edge will balance the ribbon by adding a bit of flap, keeping the arch from overflying.
I [George Peters] use the unit method... Units are 36" wide by 28" high. An ideal length is between 100 and 125 feet (33 to 42 units). You can make them longer, but beware in strong winds.
Here's the secret ingredient: trim the edges of the units into a truncated wedge, 1/4 inch in on each side of the leading edge (see drawing in above post). This will bring the ribbon in about 1/2 inch at every batten pocket on the leading edge and create the shallow curve that's needed.
The 'center' line and tow point of the Windbow are reinforced with 3/4 inch ribbon. The line is positioned one-fifth from the leading edge.
For superior lightness and strength, I use .18 Carbon rods for battens. Dowels work but they tend to break when the ribbon gets some launching twists in it.

这个是啥？彩虹桥么？

豆包帮助翻译：这段文字详细介绍了 Windbow 这款风筝的设计、制作要点和核心参数，整理如下：
1.设计起源：原型为法式“arch ribbon”风筝，由Etienne Veyres与Alain Chevalier设计，George Peters优化了气动细节，打造出这款高性能风筝玩具。
2.气动优化亮点
- 撑杆上的开放式袋状设计，能让风筝前缘形成轻微鼓泡效应，提升翼型升力，可实现头顶正上方飞行。
- 加长的后缘曲线增加少许摆动，平衡风筝姿态，避免过度前飞。
3.尺寸规格
- 基础单元尺寸：宽36英寸、高28英寸。
- 理想总长度：100–125英尺（对应33–42个基础单元），加长款需注意强风环境下的操控风险。
4.关键制作技巧
- 单元边缘修剪为截楔形，前缘两侧各向内修剪1/4英寸，使每个撑杆袋位置的前缘向内收缩约1/2英寸，形成飞行所需的平缓弧度。
- 中心线与牵引点用3/4英寸宽的带子加固，牵引点位置设在前缘1/5处。
5.撑杆选材：推荐0.18规格碳纤维杆，兼顾轻量化与强度；木杆虽可用，但在风筝起飞扭转时易断。

windbow意思是风之弓

可以尝试这种菱形风筝弓桥

感觉骨架应该是红线画的地方